Lanner-electronic FW-7890 Manuel d'utilisateur télécharger pdf (Page 44)

3.8 PnP/PCI Configuration

This section describes configuring the PCI bus system. PCI, or Personal Computer

Interconnect, is a system which allows I/O devices to operate at speeds nearing the speed the

CPU itself uses when communicating with its own special components. This section covers

some very technical items and it is strongly recommended that only experienced users should

make any changes to the default settings.

Reset Configuration Data

Normally, you leave this field Disabled. Select Enabled to reset Extended System

Configuration Data (ESCD) when you exit Setup if you have installed a new add-on and

the system reconfiguration has caused such a serious conflict that the operating system can

not boot.

Configuration options: Enabled / Disabled

Resource controlled by

The Award Plug and Play BIOS has the capacity to automatically configure all of the boot

and Plug and Play compatible devices. However, this capability means absolutely nothing

unless you are using a Plug and Play operating system such as Windows95. If you set this

field to “manual” choose specific resources by going into each of the sub menu that

follows this field (a sub menu is preceded by a “!”).

Configuration options: Auto (ESCD) / Manual

PCI/VGA Palette Snoop

Leave this field at Disabled.

Configuration options: Enabled / Disabled

Maxium Payload Size : The maximum TLP payload size for the device. As a receiver, the

device must handle TLPs as large as the set value; as transmitter, the device must not generate

TLPs exceeding the set value. range 128b ~ 4 Kb , default 4Kb PS: TLP = Transaction

Layer Packet

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 55 56

Pas de commentaire

Lanner-electronic FW-7890 Manuel d'utilisateur Page 44